LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0710 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the steering angle sensor.
  2. Test for less than 1 ohm of resistance between the ground circuit terminal 1 and ground.
    • If greater than the specified range, test for an open/high resistance in the ground circuit. If the circuit tests normal, replace the EBCM.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the EBCM.
  4. Ignition OFF, disconnect the harness connector at the EBCM.
  5. Ignition ON, test for 0 volts between the communication circuit Connector C 1 terminal 19 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  6. Test for 0 volts between the communication circuit Connector C 1 terminal 11 and ground.
    • If greater than the specified value, test the communication circuit for a short to voltage.
  7. Ignition OFF, test for infinite resistance between the communication circuit Connector C 1 terminal 19 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  8. Test for infinite resistance between the communication circuit Connector C 1 terminal 11 and ground.
    • If not the specified value, test the communication circuit for a short to ground.
  9. Test for less than 1 ohm of resistance between the communication circuit Connector C 1 terminal 19 and terminal 3.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  10. Test for less than 1 ohm of resistance between the communication circuit Connector C 1 terminal 11 and terminal 4.
    • If greater than the specified range, test the communication circuit for an open/high resistance.
  11. Test for infinite resistance between the communication circuit Connector C 1 terminal 19 and the communication circuit Connector C 1 terminal 11.
    • If not the specified value, test the communication circuits for a short together.
  12. If all circuits test normal, replace the steering angle sensor.
scientia non olet · About LEMON Manuals