Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the TDM.
- Verify that there is less than 1.0 ohm between the ground circuit terminal 3 and the negative terminal of the battery.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON. measure the voltage between the B+ circuit terminal 1 and the ground circuit terminal 3. Verify that the difference between the voltage at the TDM connector and the voltage at the battery terminals is less than 1 volt.
- If greater than the specified value, test the B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the TDM.