Circuit/System Testing
- If any other indicators are inoperative on the DIC/clock, refer to Clock Malfunction .
- Ignition OFF, disconnect the ECM harness connector X1.
- Ignition ON, the MIL should not illuminate.
- If the MIL illuminates, test the MIL control circuit terminal X1-1 for a short to ground. If the circuit test normal, replace the DIC/clock.
- Ignition ON, connect a 3A fused jumper wire between the MIL control circuit terminal X1-1 and ground. The MIL should illuminate.
- If the MIL does not illuminate, test the MIL control circuit for a short to voltage or an open/high resistance. If the circuit test normal, replace the DIC/clock.
- If the MIL illuminates, inspect for a poor connection or replace the ECM.