Installation Procedure
- Install the battery (4).
- Install the battery strap (2) and retainer (3).
- Install the battery retainer bolt (1) and tighten to 17 N.m (13 lb ft).
- Install the battery vent tube to the battery.
- Position the positive battery cable (1) to the battery.
- Tighten the positive battery cable bolt and tighten to 17 N.m (13 lb ft).
- Close the positive battery cable cover.
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Do not tip the battery more than 40 degrees during battery installation.
CAUTION:
Refer to Fastener Caution
.
IMPORTANT:
Replacement batteries may require the vent plug in the battery vent hole to be moved from one end of the battery to the other to permit vent tube installation per original design.