LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Steering Wheel Inflatable Restraint Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SDM, refer to SIR Disabling and Enabling .
  2. Rotate the steering wheel 90 degrees from the straight-ahead position to expose the access aperture hole in the rear of the steering wheel hub.
  3. Using tool no. EL-48508  , insert into the aperture and pivot towards the instrument panel moving the tool in an outward direction. This will relieve the tension on the spring-loaded retaining clips. The inflatable restraint assembly will move slightly away from the steering wheel. Rotate the steering wheel 180 degrees to expose the remaining access aperture hole. Repeat for other side.
  4. Carefully lift the steering wheel inflatable restraint assembly away from the steering wheel and disconnect the wiring harness connectors (Orange and Blue) from the rear assembly.
    5. Fig 1: Locating Wiring Harness Connectors
    GM1959109Courtesy of GENERAL MOTORS CORP.
  5. Using a suitable tool, press in on the locking tab (1) while lifting the connector (2) away from the module.
  6. Remove the black earth connector from the bottom of the steering wheel inflatable restraint assembly.
  7. Refer to Inflator Module Handling and Scrapping .
scientia non olet · About LEMON Manuals