LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Door Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Safety Glasses Caution .
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (LHD) .
  3. Remove the knee bolster. Refer to Knee Bolster Replacement .
  4. Remove the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
    5. Fig 1: Identifying Door Module Electrical Connector
    GM1939871Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the door module electrical connector (1).
    6. Fig 2: Identifying Door Module Retainers
    GM1939874Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The door module is located on the right side just under the instrument panel attached to the body.
    IMPORTANT: Pry the door module (1) with a suitable flat bladed tool then maneuver to release top locating retainer (3).
  6. Pry the door module (1) with a suitable flat bladed tool to release the retainers (3).
  7. Remove the door module (1) from the vehicle (2).
scientia non olet · About LEMON Manuals