Rear Object Alarm Module Scan Tool Information
WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Park Assist Module Scan Tool Data Parameters
| Parameter | System State | Expected Value | Definition |
|---|---|---|---|
| Operating Conditions: Ignition ON, Engine OFF, Park Assist System Enabled | |||
| Battery Voltage | - | Varies | The scan tool displays the current battery voltage. |
| Loudspeaker Feed Voltage Output | - | Varies | The scan tool displays the voltage output to the loud speaker. |
| Park Assist Disable 1-7 History | - | Varies | The scan tool displays Empty, Manual Disable, Park Brake, Hitch/Obj Attach, Reverse Ovrspeed, Inhibit, Sens Disturbance, or Sensor Ring Time. This parameter displays the last seven reasons why the park assist system was disabled in the history data. |
| Park Assist System Status | - | Enable | The scan tool displays Disable, Enable, Inhibit or Failed/Block. This parameter displays the current state of the park assist system. |
| Power Mode | - | Accessory | The scan tool displays Off, Accessory, Run or Crank Request. This parameter displays the current state of the ignition switch. |
| Rear Region 1 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Rear Region 2 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Rear Region 3 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Sensor Feed Voltage Output | - | Varies | The scan tool displays the voltage supplied to the object alarm sensors. |
| Vehicle Speed | - | 0 | The scan tool displays the vehicle speed in km/h (mph). |
Park Assist Module Scan Tool Output Controls
| Scan Tool Output Control | Description |
|---|---|
| Clear History Data | The object alarm module clears the park assist disable history when commanded by the scan tool. |