LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 6.0L, 6.2L - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal To Steering Column Support Bracket Retaining Bolts
    GM1950792Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the accelerator pedal to steering column support bracket retaining bolts (2) and tighten to 20 N.m (15 lb ft).
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Inspect for correct carpet fit under the accelerator pedal.
  5. If re-programming is required, refer to Control Module References .
  6. Install the left I/P on the lower closeout insulator panel. Refer to Knee Bolster Replacement .
scientia non olet · About LEMON Manuals