Radio Programming and Setup

Radio Programming and Setup

Each of the following service procedures requires programming or setup procedures to be performed on the radio or the Radio/HVAC Control.

Radio and Radio/HVAC Control Programming and Setup

Note: If both the radio and the Radio/HVAC Control (radio faceplate) are replaced, only the radio must be programed. If either the faceplate or the radio are replaced individually, the Radio/HVAC Control must be relinked to the radio or IRC (integrated radio controller) using Service Programming System (SPS) (Programming and Relearning)

If the radio is replaced, the following procedure must be performed:

Refer to Service Programming System (SPS) (Programming and Relearning).