Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .

Fig 1: Identifying Radio Support Bracket Screws

Courtesy of GENERAL MOTORS CORP.

Remove the screws (2) that secure the radio to the support bracket (1).
Remove the radio from the support bracket enough to access the connectors at rear of the radio.
Disconnect the electrical/audio and antenna cable connectors from the radio.
Remove the radio.

Fig 2: Locating Radio Mounting Bracket To Instrument Panel Carrier Screws

Courtesy of GENERAL MOTORS CORP.

If removing the radio mounting bracket. Perform the following steps:
1. Detach the clip retaining the HVAC harness to the radio mounting bracket.
2. Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
3. Remove the radio mounting bracket from the vehicle.