LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Antilock Brake System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the brake modulator shield mounting nuts, if equipped.
  4. Remove the brake modulator shield mounting bolt and the brake modulator shield, if equipped.
  5. Remove all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV) before loosening or removing any of the components.
  6. Disconnect the electrical connector from the EBCM.
    7. Fig 1: Identifying EBCM Bolts
    GM2001462Courtesy of GENERAL MOTORS CORP.
  7. Remove and discard the EBCM bolts (1).
    8. Fig 2: Identifying EBCM & BPMV
    GM2001464Courtesy of GENERAL MOTORS CORP.
  8. Carefully remove the EBCM (1) from the BPMV.
  9. Clean the sealing surface of the BPMV using denatured alcohol and a clean shop cloth.
scientia non olet · About LEMON Manuals