Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Strut Assembly To Body Bolts

Courtesy of GENERAL MOTORS CORP.

Position the strut assembly to the vehicle.

NOTE: Refer to Fastener Notice .

Install the 3 upper strut mount bolts.
Tighten: Tighten the upper strut mount bolts to 25 N.m (18 lb ft).

Fig 2: Identifying Steering Knuckle To Strut Bolts & Nuts

Courtesy of GENERAL MOTORS CORP.

Install the lower strut bolts and nuts.
Tighten: Tighten the bolts and nuts to 200 N.m (148 lb ft).

Fig 3: Identifying Stabilizer Link Retaining Nut

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Inspect the stabilizer link seals for damage prior to installation. Replace as required.

IMPORTANT: Do not allow the stabilizer link ball stud to rotate while installing the link nut.

Position the stabilizer link to the strut and install the nut.
Tighten: Tighten the nut to 65 N.m (48 lb ft).

Fig 4: View Of Brake Hose Bracket & Strut Assembly

Courtesy of GENERAL MOTORS CORP.

Position the brake hose bracket to the strut assembly and install the bolt.
Tighten: Tighten the brake bracket bolt to 15 N.m (11 lb ft).
Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.
Perform a wheel alignment. Refer to Wheel Alignment Measurement .