Circuit/System Testing: Notes
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the schematic to identify the following:
- Control modules the vehicle is equipped with
- Control module locations on the low speed GMLAN serial data circuit
- The low speed GMLAN serial data circuit terminals for each control module
- Attempt to communicate with all control modules on the low speed GMLAN serial data circuit, refer to Data Link References . Communications should not be available with two or more control modules on the low speed GMLAN serial data circuit.
- If only one control module is not communicating, diagnose that control module only, refer to DTC U0100-U0299 .
- If one or more control modules are communicating but not all, refer to Testing the Serial Data Circuit for an Open/High Resistance .
- Disconnect the scan tool from the DLC. The following tests will be done at the DLC connector.
- All access doors closed, ignition OFF for 60 seconds, test for less than 10 Ω between the ground circuit terminal 5 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, test for less than 4.5 V between the serial data circuit terminal 1 and ground.
- If greater than the specified range, test the serial data circuit for a short to voltage, refer to Testing the Serial Data Circuit for a Short to Voltage .
- Ignition OFF for 60 seconds, test for greater than 100 Ω between the serial data circuit terminal 1 and ground.
- If less than the specified range, test the serial data circuit for a short to ground, refer to Testing the Serial Data Circuits for a Short to ground .
- Disconnect the appropriate harness connector at the JX 200 splice pack.
- Test for less than 2 Ω between the DLC serial data circuit terminal 1 and the JX200 splice pack terminal 1.
- If greater than the specified range, test the serial data circuit for an open/high resistance. If the circuits test normal, replace the splice pack.