Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing BCM Into Bracket

Courtesy of GENERAL MOTORS CORP.

Install the BCM (1) into the bracket.
Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 2: Locating Body Control Module Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors (2) to the BCM (1).

Fig 3: Identifying Right Side Knee Bolster Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
If you replaced the BCM, program the module. Refer to Body Control Module Programming and Setup .
Refer to Control Module References for programming and setup information.