LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2009 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 149 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B1E3A >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at each of the object sensors.
  2. Ignition ON, verify DTC B1E3A is not set as current.
    • If the DTC is set, test the 8-volt reference circuit terminal 1 for a short to voltage, short to ground, or an open/high resistance. If circuit tests normal, replace the object alarm module.
  3. Install each sensor harness connector one at a time, checking DTCs after each sensor is connected. Verify DTC B1E3A is not set as current.
    • If the DTC is set, replace the object sensor that was connected immediately before the DTC set.