Communication Interface Module Battery Replacement

Communication Interface Module Battery Replacement

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

1. Disconnect the battery ground cable.




2. Slide the passenger seat rearward.
3. Disconnect the electrical connector from the OnStar module which is located on the bottom of the passenger seat.
4. Remove the bolts (1) and the OnStar battery (2).

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the OnStar battery (2) with the bolts (1) and tighten to 3 Nm (27 lb in).
2. Restore the seat position.
3. Connect the electrical connectors.
4. Connect the negative battery cable.