LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Pontiac >> 2010 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 1.8L (Lay) - Repair Instructions >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Gasket & Intake Manifold
    GM2016612Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket (1) onto the intake manifold.
    2. CAUTION: Refer to Fastener Caution
  2. Install the throttle body assembly with the 2 bolts and 2 nuts and tighten to 10N.m (7 lb ft).
    3. Fig 2: Identifying Throttle Body Connector & Water By-Pass Hoses
    GM2016610Courtesy of GENERAL MOTORS CORP.
  3. Connect the 2 water by-pass hoses (2) and the throttle body connector (1).
  4. Install the air cleaner cap sub-assembly with hose and lock the 2 clamps.
    5. Fig 3: Hose Clamp
    GM2016613Courtesy of GENERAL MOTORS CORP.
  5. Tighten the hose clamp (1) to 2.0N.m (18 lb in).
    6. Fig 4: Identifying Ventilation Hose & Hose Clamps
    GM2016614Courtesy of GENERAL MOTORS CORP.
  6. Connect the ventilation hose (1).
    7. Fig 5: Mass Air Flow Meter Connector & Wire Harness Clamps
    GM2016606Courtesy of GENERAL MOTORS CORP.
  7. Connect the wire harness clamp (1, 2) and mass air flow meter connector (3).
  8. Add engine coolant. Refer to Cooling System Draining and Filling .
  9. Inspect for a coolant leak.
  10. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About LEMON Manuals