Important Notes: Adaptation

The DME control module must perform a learning and adaptation routine if:

• The battery was disconnected
• The DME control module connector was unplugged
• A new DME control module has been installed
• The throttle part has been replaced.

To initiate adaptation:

1. Switch on the ignition for 1 minute without  starting the engine.

   Do not press the accelerator.

2. Switch off the ignition for at least 10 seconds.

The following conditions must be fulfilled, otherwise learning is not possible:

• Stationary vehicle
• Accelerator pedal angle < 0.8 %
• Battery voltage > 10 V
• Engine temperature between 5° C and 100° C
• Intake air temperature > 10° C