Disassembling And Assembling
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE
| No. | Designation | Qty. | Removal | Installation | ||
|---|---|---|---|---|---|---|
| 1(1) | Release lever | 1 | ||||
| 2(1) | Release bearing | 1 | Do not wash out bearing, replace noisy bearings, do not grease sliding surface of release bearing or guide tube. | |||
| 3(1) | Retainer spring | 1 | ||||
| 4(1) | M8 x 16 pan-head screws | 6 | To avoid deforming the thrust plate housing the screws must be loosened in several stages and in diametrically opposite sequence. | To avoid deforming the thrust plate housing the screws must be tightened in several stages and in diametrically opposite sequence. Observe tightening torque. | ||
| 5(1) | Thrust plate | 1 | ||||
| 6(1) | Drive plate | 1 | Fit using special tool (centring mandrel) 3176. | |||
| 7(1) | M10 x 1 x 50 pan-head screws | 8 | Observe tightening specification. | |||
| 8(1) | Double-mass flywheel (DMF) | 1 | Ensure the centring pins are seated firmly. | |||
| 9(1) | Needle bush | 1 | ||||
|
||||||