Programming gateway control module
- If the gateway control module is replaced, the gateway control module must be programmed or coded with the PIWIS tester. This is to adapt the Gateway control module to the vehicle and equipment.
- Before the gateway control module is removed, the vehicle data should be read out with the PIWIS tester if possible.
- If reading out the data is not possible, the new gateway control module must be coded. → Coding gateway control unit .
- The power supply for the PIWIS tester must be ensured while reading out the data. It is essential to connect a battery charger with a current rating of at least 40 A to the vehicle battery.
- The PIWIS tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations may occur with later software versions.
- The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester.
1. Connect the PIWIS tester P 9718 to the vehicle and start it. Switch on the ignition. >> Continue.
2. Select vehicle type and continue with >>.
3. Select the gateway control module and continue with >>.
4. Select Control module replacement and continue with >>.
5. Select Read-out values and continue with >>.
6. On the screen of the PIWIS tester, the following information appears Coding read-out complete . >> continue.
7. Switch off ignition and replace Gateway control module. → Removing gateway control module .
8. Switch on ignition, after replacing the gateway control module the read-out data are installed in the Values menu. >> continue.
9. On the screen of the PIWIS tester, the following information appears Coding write-in complete . >> continue.
10. Follow the instructions on the PIWIS tester.
11. Read out the fault memory and, if necessary, erase it.