Wheel Alignment - Specifications & Adjustments: Toe-In
If toe-in is not to specifications, disconnect steering arm at rack end. Loosen lock nut on steering end fitting. To increase toe-in, unscrew end fitting. To decrease, screw in fitting. Tighten lock nut and connect steering arm. Recheck toe-in.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Caster (Degrees) | Camber (Degrees) | Toe-In (Inches) | Toe-Out On Turns (Degrees) | ||
|---|---|---|---|---|---|---|
| Inner | Outer | |||||
| All Models | ||||||
| Front | 4 | 3/64 to 5/32 | 1 1/2 ± 1/2 | |||
| Rear | 0 ± 1/2 | 0 to 1/16 | ||||