Ground Circuit
WARNING: This page is about a different car, the 1992 Saab 9000 and 1992 Saab 900. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition off. Locate ignition control unit in engine compartment, forward of left front wheel housing. Connect negative lead of ohmmeter to ground. Backprobe ECU terminal No. 20 (Black wire). Resistance should be zero ohms. If not, repair open to ground. Harness grounding point is located on engine lift bracket.
- Connect negative lead of DVOM to a good ground. Backprobe ECU terminal No. 20. With vehicle running, DVOM should indicate less than one volt. If voltage is higher than one volt, check for open, corrosion or loose connection on ground lead.