LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 1995 >> 9000 CS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - Aw50-40LE >> Component Testing >> Brake Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Switch

  1. Ensure ignition is off. Remove underdash panel on left side to gain access to brake switch, located at top of brake pedal lever. Connect a voltmeter between brake switch terminal No. 2 (Yellow/Gray wire) and a good known ground. Battery voltage should be present. If battery voltage is not present, check for open circuit between terminal No. 2 and brake switch fuse (No. 17, 10 amp).
  2. Disconnect brake switch connector. Connect an ohmmeter between brake switch terminals No. 1 (Violet wire) and No. 2 (Yellow/Gray wire). With brake pedal released, resistance should be infinite. With brake pedal depressed, resistance should be zero ohms. If resistance is not as specified, replace brake switch.
scientia non olet · About LEMON Manuals