LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2000 >> 9-5 Base, 4D Sedan, Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Automatic A/C-Heater Systems - 9-5 >> Programming >> Acc Control Module Programming >> Extended User Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Extended User Programming

NOTE: Extended user programming allows user to change activation parameters of certain automatic functions. These selections are stored and used by ACC control module until programming is cancelled, activating default parameters.
  1. Turn ignition on. To program or cancel an automatic function, press ECON, air recirculation control, or heated rear window control button. See Figure. Hold button until selected function symbol is displayed, flashes 4 times, and a chime is sounded. During programming a message will be displayed on Saab Information Display (SID). When programming is done, AUTO will still be displayed on ACC control panel.
  2. During ECON programming, SID will display ACC: LOW TEMP A/C CTRL. During ECON program cancelling, SID will display ACC: NORMAL A/C CTRL. The ACC control module automatic default selection of ECON function will occur when outside temperature is less than 50°F (10°C) and calculated solar intensity is less than a specific value. ECON function will disengage when outside temperature is more than 55°F (13°C) or calculated solar intensity is more than a specific value. ACC control module will not accept increased temperatures if vehicle speed is less than 19 MPH. ACC control module can be programmed using a scan tool so ECON is selected at other temperatures.
  3. During air recirculation control programming, SID will display ACC: RECIRC ACC: SPEED CTRL. During air recirculation control program cancelling, SID will display ACC: RECIRC ACC: NORMAL CTRL. The ACC control module automatic default selection for air recirculation function will occur when vehicle speed is less than 6 MPH. Air recirculation function will disengage when vehicle speed is more than 19 MPH. In addition, vehicle speed must have exceeded 19 MPH at least once during trip for air recirculation function to activate. ACC control module can be programmed using a scan tool to automatically select air recirculation at other vehicle speeds.
  4. During heated rear window control programming, SID will display ACC: AUTO RDEFR CTRL. During heated rear window control program cancelling, SID will display ACC: MANUAL RDEFR CTRL. The ACC control module automatic default request for electrically heated rear window and door mirrors function occurs 5 seconds after engine has been started when outside temperature is less than 41°F (5°C) and cabin temperature is less than 50°F (10°C). Heated rear window function will remain active for 2 minutes when outside temperature is 41°F (5°C) and up to 10 minutes when outside temperature is less than 14°F (-10°C).
scientia non olet · About LEMON Manuals