LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2006 >> 9-7X 5.3i >> Repair and Diagnosis >> Body & Frame >> Windows >> Stationary Windows >> Repair Instructions >> Windshield Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install a stationary window into the opening. Refer to URETHANE ADHESIVE INSTALLATION OF STATIONARY WINDOWS .
    2. Fig 1: Removing Reveal Molding
    GM398501Courtesy of GENERAL MOTORS CORP.
  2. Install the windshield side reveal moldings.
    3. Fig 2: Removing Window Side Reveal Molding Screws
    GM398502Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in cautions and notices.
  3. Install the windshield side reveal moldings screws.

    Tighten:  Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).

    4. Fig 3: View Of Front Door Sealing Weatherstrip
    GM441415Courtesy of GENERAL MOTORS CORP.
  4. Reposition the front door sealing weatherstrips (1) to the pinch-weld flange.
    5. Fig 4: Removing/Installing Weather-Strip Retainers
    GM588275Courtesy of GENERAL MOTORS CORP.
  5. Install the push-pin retainers (2) to the front door sealing weatherstrips located at the base of the windshield pillar.
  6. Install the cowl air inlet grille panel. Refer to AIR INLET GRILLE PANEL REPLACEMENT in body front end.
  7. Install the windshield wiper arms. Refer to WIPER ARM REPLACEMENT in wipers/washer systems.
  8. Install the antenna mast if equipped. Refer to FIXED ANTENNA MAST REPLACEMENT in entertainment.
  9. Install the rearview mirror. Refer to REARVIEW MIRROR REPLACEMENT .
  10. Install the rain sensor. Refer to WINDSHIELD OUTSIDE MOISTURE SENSOR REPLACEMENT in wipers/washer systems.
  11. Close the hood.
  12. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
scientia non olet · About LEMON Manuals