Installation Procedure

If necessary, install the TAC module bracket (1) and nuts (2).
Tighten: Tighten the nuts to 9 N.m (80 lb in).

Fig 1: View Of TAC Module
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Handling Electrostatic Discharge Sensitive Parts Notice .

NOTE: Refer to Fastener Notice .
Install the TAC module (3) to the retaining bracket (1).
Snap the TAC module (3) into retaining tab.
Connect the engine harness electrical connector.

Fig 2: View Of Engine Harness Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Connect the I/P harness electrical connector.

Fig 3: View Of I/P Harness Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Install the bulk connector to the bracket.
Refer to Control Module References for programming and setup information.