LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saab >> 2008 >> 9-7X 4.2i >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Powertrain Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Removing/Installing PCM & Bracket
    GM1863835Courtesy of GENERAL MOTORS CORP.
  1. If the PCM and bracket were removed, perform the following steps, otherwise proceed to step 4.
  2. Install the PCM bracket w/PCM to the studs.
    3. NOTE: Refer to Fastener Notice .
  3. Install the PCM bracket bolts and nuts

    Tighten:  Tighten the bolts/nuts to 9 N.m (80 lb in).

    4. Fig 2: Removing/Installing PCM
    GM1863837Courtesy of GENERAL MOTORS CORP.
  4. Set the PCM into the bottom retainer on the bracket and push the PCM rearward, engaging the 2 top retainers.
    5. Fig 3: Locating PCM & Engine Wiring Harness Electrical Connectors
    GM1863834Courtesy of GENERAL MOTORS CORP.
    NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
  5. Connect the engine wiring harness electrical connectors (1) to the PCM.
    6. Fig 4: Locating PCM & Instrument Panel Wiring Harness Electrical Connector
    GM1863833Courtesy of GENERAL MOTORS CORP.
    NOTE: In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.
  6. Connect the I/P wiring harness electrical connector (1) to the PCM.
  7. If a NEW PCM was installed, program the PCM. Refer to Control Module References .
  8. Using a scan tool, set the remaining engine oil life.
scientia non olet · About LEMON Manuals