Electronic Brake Control Module (EBCM) Programming

To program and setup an existing or new replacement EBCM, perform the following procedure:

1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to SERVICE PROGRAMMING SYSTEM (SPS) .
2. On the SPS Supported Controllers screen, select EBCM Electronic Brake Control Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select EBCM Electronic Brake Control Module - Setup and follow the on-screen instructions.

If the EBCM fails to accept the program, verify all scan tool and EBCM connections are secure.

1. Turn the ignition OFF, for 10 seconds.
2. Open and close the door.
3. Install the scan tool to the data link connector.
4. Ignition ON, engine OFF.
5. With a scan tool, clear all DTC's from all modules.

The following service procedures require either a programming or a setup event performed for a complete repair.