Engine Prelubing

Special Tools 

• EN 21867-6  Oil Pressure Adapter Fitting
• EN 45299  Engine Preluber

1. NOTE: A constant and continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.

   Remove the oil filter cap.

2. Install the NEW oil filter cartridge.
3. Lubricate the threads of the oil filter cap with clean engine oil.
4. Refer to FASTENER CAUTION .

   Install the oil filter cap and tighten to 25 Nm (18 lb ft)  .

5. Remove the oil pressure sending unit from the oil filter adapter.
Fig 1: Identifying Oil Pressure Sending Unit
Courtesy of SAAB-SCANIA OF AMERICA, INC.
6. Install the EN 21867-6  fitting.
7. Install the flexible hose to the adapter and open the valve.
   Fig 2: Identifying Preluber (EN 45299)

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
8. Pump the handle on the EN 45299  preluber in order to flow a minimum of 1-1.9 liters (1-2 quarts) of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
9. Close the valve and remove the flexible hose and adapter from the engine.
10. Install the oil pressure sending unit and tighten to 20 Nm (15 lb ft)  .
11. Top-off the engine oil to the proper level.