Throttle Position Sensor: Service and Repair

Throttle Position Sensor On Side Of Throttle Body:

REMOVAL


1. If required, remove TPS attachment screws and TPS.


INSTALLATION

1. With throttle body valve closed, install TPS on throttle body shaft. Rotate TPS counterclockwise to align mounting holes.

2. Install TPS attachment screws.
^ Torque: 2 Nm (18 in lbs)


CAUTION: The TPS is an electrical component, and must not be soaked in any liquid solvent or damage may result.

NOTE: The TPS is not adjustable. Turning the ignition "OFF" and "ON" will reset the TPS value. Closed throttle voltage limits are 0.35 volt to 0.70 volts.