LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 1994 >> SC2 Standard >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Testing >> Front >> Wipers Run At Low Speed Only Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wipers Run At Low Speed Only Test

  1. Disconnect column switch connector. Turn ignition on. Connect test light between cavity "A" and ground. If test light is on, go to next step. If light is off, check for open or short in ground circuit No. 153F (Black wire). Reconnect connectors.
  2. Disconnect wiper motor module connector. Check for battery voltage between module connector cavity "C" and column switch connector cavity "B". Voltage should be present with ignition switch in ACC and RUN positions. If voltage is present, go to next step. If no voltage is present, repair open or short in circuit No. 92 (Purple wire).
  3. Perform wiper switch resistance checks. See WIPER/WASHER SWITCH RESISTANCE  table. If resistance checks are okay, check for opens at pins "A", "B" and "C" on column switch connector and repair as needed. If wiper switch checks are okay, go to next step. If wiper switch does not check okay, install new wiper switch and verify that wipers operate.
  4. Check circuits, connections and terminals connected to wiper module. Repair as needed. If system still does not operate, replace wiper module/motor assembly. Verify that system operates with new components.