ABS/PCM Bracket

PCM/ABS Bracket:

REMOVAL

1. Remove powertrain control module.
2. Loosen ABS control module attachment nut at cross car beam and lift ABS control module upward (towards windshield) to disengage ABS control module from ABS/PCM bracket.
3. Remove nuts holding ABS/PCM bracket to steering column support bracket.
4. Remove ABS/PCM bracket.


INSTALLATION

1. Install ABS/PCM bracket stud through hole in steering column support bracket.
2. Install and torque nut.
- Torque: 6 N.m (54 in.lbs.)
3. Lower ABS control module into ABS/PCM bracket while guiding attachment stud into slot in cross car beam.

NOTE: Torque is critical to preserve the integrity of the plastic insulator on the PCM case. Damage to the PCM can result from over torque of the nut.

4. Torque nut.
- Torque: 10 N.m (89 in.lbs.)
5. Install powertrain control module.