Fuel Pump Relay

When ignition switch is turned to the ON position, PCM will turn on electric fuel pump by energizing the fuel pump relay. PCM will keep relay energized if engine is running or cranking (PCM is receiving reference pulses from ignition control module). If no reference pulses exist, PCM turns pump off within 2 seconds after key on.

As a back-up system to fuel pump relay, fuel pump is also activated by the oil pressure switch. The oil pressure switch is normally open until oil pressure reaches about 4 psi (.28 kg/cm² ). If fuel pump relay fails, the oil pressure switch closes when oil pressure is obtained, operating the fuel pump. An inoperative fuel pump relay may result in extended cranking times due to the time required to build up oil pressure. Oil pressure switch may be combined into a single unit with an oil pressure gauge sender or sensor.

For additional information on fuel pump activation, see appropriate BASIC DIAGNOSTIC PROCEDURES and SYSTEM & COMPONENT TESTING articles.