Door Control Modules (Hardtop Only)

WARNING: This page is about a different car, the 2000 Chevrolet Corvette and 1999 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before performing this procedure, check for proper communications between Door Control Module (DCM) and scan tool. If DCM does not communicate with scan tool, go to POWER DOOR SYSTEMS DIAGNOSTIC SYSTEM CHECK .

DCM must be programmed after replacement. The DCM stores information regarding the vehicle option content. If DCM is programmed with correct option content, default values will set for some systems which could cause system malfunctions. Maintain the battery voltage while the DCM is in the programming mode. Using scan tool, select DCM that was replaced. Select DCM REPROGRAM. Follow on screen instructions.