LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2002 >> SC1 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Electronic Suspension System - Automatic Level Control) >> Repair Instructions >> Automatic Level Control Air Compressor Head Replacement >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new gasket on the air compressor.
  2. Install the air compressor head on the air compressor with the 3 bolts.

    Tighten 

    Tighten the bolts to 6 N.m (53 in lbs).

  3. Connect the air hose.
  4. Install the 2 wire terminals in the air compressor connector.
    Fig 1: Installing Air Compressor Head
    G01582140Courtesy of GENERAL MOTORS CORP.
  5. Install the wrap around 4 wires and secure with 2 harness ties.
  6. Install the wiring harness and the harness clamp on the air compressor head with the bolt.

    Tighten 

    Tighten the bolt to 3 N.m (26 in lbs).

  7. Install the air dryer. Refer to Automatic Level Control Air Dryer Replacement .
    Fig 2: Installing Wiring Harness & Harness Clamp
    G01582141Courtesy of GENERAL MOTORS CORP.
  8. Install the heat shield with the 2 bolts.

    Tighten 

    Tighten the bolts to 4 N.m (35 in lbs).

  9. Connect the air compressor connector to the connector anchor.
  10. Install the air compressor on the vehicle. Refer to Air Compressor Replacement .
    Fig 3: Installing Heat Shield & Bolts
    G01582142Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals