Removal & Installation: Console: Removal

Disable SIR system. See appropriate AIR BAG RESTRAINT SYSTEMS article in ACCESSORIES & EQUIPMENT. Apply parking brake lever.
Remove window mirror switch (if equipped) by performing the following:
- Exert pressure on rear of window mirror switch with hand.
- Pry up with blunt tool at rear retainer assembly tabs. See Fig 1 .
- Lift window mirror switch up and out. See Fig 2 .
- Disconnect electrical connector by locating retention tabs and disengaging connectors.
Adjust front seats to most forward position. Remove rear console screws. See Fig 3 . Adjust front seats to most rearward position. Remove left and right lower trim panel extensions by pulling outward at dual lock locations. See Fig 4 .
Rotate panels outward to disengage hinges from console. Remove front console screws. See Fig 5 . Move console rearward. Disengage retaining tabs and disconnect power outlet connector.
Maneuver console beyond gear selector and parking brake by lifting rear of console. See Fig 6 . Remove console from vehicle.

Fig 1: Releasing Window/Mirror Switch Retainers (Automatic Shown; Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing Window/Mirror Switch (Automatic Shown, Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 3: Removing & Installing Rear Console Retainers (Automatic Shown, Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 4: Removing & Installing Side Panels (Automatic Shown, Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 5: Removing & Installing Front Console Screws (Automatic Shown, Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.

Fig 6: Removing & Installing Console Assembly (Automatic Shown, Manual Is Similar)

Courtesy of GENERAL MOTORS CORP.