April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission General Specifications

Gear Teeth Counts and Ratios

Gear	Gear Teeth Count
1st Drive	13
1st Driven	44
2nd Drive	25
2nd Driven	44
3rd Drive	39
3rd Driven	46
4th Drive	47
4th Driven	42
5th Drive	54
5th Driven	38
Reverse Drive	25
Reverse Idler	21
1st & 2nd Gear Synchronizer Sleeve	49
Output Shaft	20
Ring Gear	89

Blocking Ring Clearances

Measure	Standard		Service Limit
Measure	Metric	English	Metric	English
1st and 2nd Gears	1.2-1.4 mm (min.)	0.047-0.055 in (min.)	0.8 mm (min.)	0.032 in (min.)
3rd, 4th, and Reverse Gears	0.9-1.2 mm (min.)	0.035-0.047 in (min.)	0.5 mm (min.)	0.020 in (min.)
5th Gear	0.7-1.1 mm (min.)	0.028-0.043 in (min.)	0.5 mm (min.)	0.020 in (min.)

Axial Play Specifications

Measurement	Specification
Measurement	Metric	English
Between 2nd and 3rd Drive Gears	0.05-0.40 mm	0.002-0.016 in
Between 4th Drive Gear and Input Shaft Bearing	0.05-0.40 mm	0.002-0.016 in
Between Reverse Gear and Reverse Gear Washer	0.10-0.20 mm	0.004-0.008 in
Input Shaft Axial Play	0.09-0.15 mm	0.004-0.006 in
Output Shaft Axial Play	This is a calculated value. It can change based upon age of case and output shaft bearing. Refer to Transaxle Assemble .