LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2003 >> LW200 >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Removing & Installing Multifunction Switch Housing
    GM891592Courtesy of GENERAL MOTORS CORP.
  1. Slide the bracket onto the column.
  2. Hand tighten the lower bolt until snug.
  3. Hand tighten the upper bolt until snug.
    4. NOTE: Refer to FASTENER NOTIC in Cautions and Notices.
  4. Tighten the lower bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in).

  5. Tighten the upper bolt.

    Tighten:  Tighten the bolt to 8 N.m (71 lb in).

    6. Fig 2: View Of Ignition Housing Electrical Connectors
    GM928832Courtesy of GENERAL MOTORS CORP.
  6. Connect the ignition housing electrical connectors.
    7. Fig 3: Removing & Installing Multi-Function Levers
    GM891750Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that both locking tabs are seated.
  7. Install the multi-function levers.
    8. Fig 4: Lower Steering Column Cover & Screws
    GM870643Courtesy of GENERAL MOTORS CORP.
  8. Install the upper and lower shrouds. Refer to Steering Column Trim Covers Replacement .

    Tighten:  Tighten the shroud screws to 4 N.m (35 lb in).

  9. Install the SIR coil. Refer to SIR COIL ASSEMBLY in Air Bag Restraint Systems.
  10. Install the steering wheel. Refer to Steering Wheel Replacement .
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals