LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Ion Red Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Engine Controls - Introduction) >> Repair Instructions >> Accelerator Pedal Position (APP) Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion Red Line. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the attachment bolts into the APP assembly.

    Tighten:  Tighten the accelerator pedal position assembly-to-brake bracket bolt to 9 N.m (80 lb in).

    4. Fig 1: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the APP sensor connect CPA.
scientia non olet · About LEMON Manuals