Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn Ion 3, 2005 Saturn Ion 2, and 2005 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

IMPORTANT: The KS threaded surfaces must be clean before installation.

Install the knock sensor.
Tighten: Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

Fig 1: View of Knock Sensor

Courtesy of GENERAL MOTORS CORP.

Connect the knock sensor harness connector.
Install the starter. Refer to Starter Motor Replacement (2.2L (L61)) or Starter Motor Replacement (2.0L (LSJ)) in Engine Electrical.