Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Ion Red Line, 2007 Saturn Ion 3, and 2007 Saturn Ion 2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Wipers/Washer Signal Switch Retaining Screws

Courtesy of GENERAL MOTORS CORP.

Install the wiper washer switch to the SIR coil module assembly.
Install the wiper washer switch screws.

Fig 2: View Of Headlamp/Turn Signal Switch

Courtesy of GENERAL MOTORS CORP.

Install the head lamp/turn signal switch to the SIR coil module assembly.
Install the headlamp/turn signal switch screws.

Fig 3: View Of SIR Coil Assembly

Courtesy of GENERAL MOTORS CORP.

Verify the SIR coil is in the center position. Refer to Inflatable Restraint Steering Wheel Module Coil Centering .
Slide the SIR coil assembly on the steering column and snap into place.

Fig 4: View Of SIR Coil Module Assembly Harness Connectors

Courtesy of GENERAL MOTORS CORP.

Connect the wiper/washer harness connector to the SIR coil module assembly.
Connect the head lamp/turn signal harness connector to the SIR coil module assembly.
Connect the SIR coil harness connector to the SIR coil module assembly.
Install the steering column covers. Refer to Steering Column Trim Covers Replacement (Except Redline) or Steering Column Trim Covers Replacement (Redline) .
Install the steering wheel. Refer to Steering Wheel Replacement .
Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .