LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) -- 2.2L (L61) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View of Ignition Module Housing Assembly With Spark Plug Boots
    GM951506Courtesy of GENERAL MOTORS CORP.
  1. Apply dialectic compound to the spark plug boots and ensure no corrosion is present.
    2. Fig 2: View Of Ignition Module Assembly With Spark Plug Boots
    GM894939Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition module housing assembly with spark plug boots into position.

    Tighten:  Tighten the ignition module-to-camshaft cover bolts to 10 N.m (89 lb in).

    3. Fig 3: View Of El Module & Attachment Screws
    GM896789Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the interconnect is line up and the interconnect seal is in place before installing the attachment screws.
  3. Install the EI module and attachment screws (if removed).

    Tighten:  Tighten the module screws to 1.5 N.m (13 lb in).

  4. Connect the EI module harness connector. Push in the connector until a slick is heard, then pull back to confirm a positive engagement.
    5. Fig 4: View Of Outlet Resonator/Duct Assembly
    GM897621Courtesy of GENERAL MOTORS CORP.
  5. Position the outlet resonator/duct assembly into position.
  6. Connect the PCV fresh air bent hose assembly.
  7. Tighten the clamp at the throttle body assembly.
  8. Position the outlet resonator/duct assembly up with the support bracket and install the push-pin.
  9. Tighten the clamp at the air cleaner assembly.
  10. Connect the intake air temperature (IAT) sensor connector.
scientia non olet · About LEMON Manuals