LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2004 >> Vue Base, 2.2 D, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Introduction) -- 2.2L (L61) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Intake Manifold Opening With A Clean Shop Towel
    GM951566Courtesy of GENERAL MOTORS CORP.
  1. Remove the shop towel from the throttle body opening.
    2. Fig 2: View Of Throttle Body Assembly & Bolts
    GM947783Courtesy of GENERAL MOTORS CORP.
  2. Install the throttle body gasket.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body assembly and bolts.

    Tighten:  Tighten the throttle body-to-intake manifold bolts - L61 to 10 N.m (89 lb in).

    4. Fig 3: View Of Throttle Body Electrical Connector
    GM947518Courtesy of GENERAL MOTORS CORP.
  4. Connect the throttle body electrical connector.
    5. Fig 4: Identifying Outlet Resonator/Duct Assembly
    GM898897Courtesy of GENERAL MOTORS CORP.
  5. Position the outlet resonator/duct assembly into position.
  6. Connect PCV fresh air vent hose assembly.
  7. Tighten the clamp at throttle body assembly.
  8. Position the outlet resonator/duct assembly up with support bracket and install the push-pin.
  9. Tighten the clamp at the air cleaner assembly.
  10. Connect the intake air temperature (IAT) sensor connector.
  11. Turn the ignition ON for one minute while the engine control module (ECM) automatically relearns throttle position.
scientia non olet · About LEMON Manuals