Installation Procedure
- Connect the wiper module electrical connector to the motor.
- Connect the wire harness rosebud clip to the wiper module frame.
- Install the wiper module assembly into the plenum.
- Install the fasteners attaching the wiper module assembly to the plenum.
Tighten: Tighten the fasteners to 12 N.m (9 lb ft)
- Turn the key to RUN position and cycle wiper system to ensure motor is in the park position.
- Install the air inlet screens. Refer to Air Inlet Grille Panel Replacement in Body Front End.
- Install the wiper arms. Refer to Wiper Arm Replacement .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.