Installation Procedure

WARNING: This page is about a different car, the 2004 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the control assembly into the vehicle and install the control assembly-to-floor pan bolts. Tighten: Tighten the control assembly-to-floor pan bolts to 8 N.m (71 lb in).

Fig 1: Removing & Installing Shift Control Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the control assembly electrical connectors.

Fig 2: Removing & Installing Shift Lock Control Assembly Electrical Connectors
Courtesy of GENERAL MOTORS CORP.
Connect the control cable to the pin on the control assembly.
Secure the control cable into the control assembly by pushing into place.
Install the control cable retaining clip.

Fig 3: Removing & Installing Shift Control Cable From Control Assembly

Courtesy of GENERAL MOTORS CORP.

Install the console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
Enable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.