LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> L300 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Shift Control Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Removing & Installing Shift Control Assembly
    GM893837Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the control assembly into the vehicle and install the control assembly-to-floor pan bolts.

    Tighten:  Tighten the control assembly-to-floor pan bolts to 8 N.m (71 lb in).

    2. Fig 2: Removing & Installing Shift Lock Control Assembly Electrical Connectors
    GM893835Courtesy of GENERAL MOTORS CORP.
  2. Connect the control assembly electrical connectors.
    3. Fig 3: Removing & Installing Shift Control Cable From Control Assembly
    GM893834Courtesy of GENERAL MOTORS CORP.
  3. Connect the control cable to the pin on the control assembly.
  4. Secure the control cable into the control assembly by pushing into place.
  5. Install the control cable retaining clip.
  6. Install the console. Refer to Console Replacement .
scientia non olet · About LEMON Manuals