Front Toe Adjustment
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the power steering gear seal small clamps.
- Verify that the steering wheel is centered and the wheels are in the straight ahead position.
- Loosen the left and right tie rod jam nuts (2).
- Rotate the inner tie rods in order to obtain the proper toe angle of 0 degrees.
- Tighten the tie rod end jam nuts.
Tighten: Tighten the left and right tie rod jam nuts (2) to 68 N.m (50 lb ft).
- Install the power steering gear seal small clamps.
IMPORTANT:
Verify that the number of threads showing on both inner tie rod ends are approximately equal.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Verify that the power steering gear seal is not twisted.