LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing Generator Bracket Bolts
    GM1239046Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts in sequence to 50 N.m (37 lb ft).

    3. Fig 2: Removing Drive Belt Tensioner Bolt
    GM1239042Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt tensioner.
  4. Install the drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  5. Install the drive belt idler pulley.
  6. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    7. Fig 3: Removing Drive Belt
    GM1239067Courtesy of GENERAL MOTORS CORP.
  7. Install the generator. Refer to Generator Replacement (L61)  or Generator Replacement (LX9) .
  8. Rotate the drive belt tensioner counterclockwise.
  9. Install the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 3.5L (LX9).
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals