LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 195 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Control Arm
    GM156958Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm.
  2. Install the control arm bolts and nuts.
    3. IMPORTANT: Align the ball stud cotter pin hole parallel to the knuckle in order to ease the cotter pin installation.
  3. Install the ball stud to the knuckle.
    4. NOTE: Refer to Fastener Notice .
  4. Install the ball stud castle nut.

    Tighten:  Tighten the ball stud castle nut to 30 N.m (22 lb ft) plus 135 degrees.

    5. Fig 2: Aligning Ball Stud Castle Nut Slot To The Ball Stud Cotter Pin Hole
    GM384426Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do NOT loosen the ball stud nut in order to align the ball stud nut slots to the ball stud cotter pin hole.
  5. If necessary, tighten the ball stud castle nut in order to align the ball stud castle nut slot (1) to the ball stud cotter pin hole (2) as shown.
    6. Fig 3: Securing Cotter Pin In Ball Joint Castle Nut
    GM384428Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the cotter pin ends do NOT contact the ABS wheel speed sensor, the ABS sensor connector or the drive axle.
  6. Install a NEW cotter pin and bend the ends as shown in either example.
  7. Install the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement (with Rear IRS)  or Stabilizer Shaft Link Replacement (with Rear Twist Axle) .
  8. Install the ABS wheel speed sensor jumper harness to the harness retainer clips. Refer to Front Wheel Speed Sensor Replacement .
    9. Fig 4: View Of Wheel Speed Sensor, Connector And Harness
    GM188809Courtesy of GENERAL MOTORS CORP.
  9. Install the ABS wheel speed sensor connector (2).
    10. IMPORTANT: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
    • The fastener and its counterpart are clean and free from rust.
    • The fastener develops 3 N.m (27 lb in) of torque/drag against its counterpart prior to the fastener seating.

    If the fastener does not meet these criteria, replace the fastener.
  10. Install the lower control arm nuts.

    Tighten:  Tighten the lower control arm nuts to 96 N.m (71 lb ft).

  11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation  .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals