LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Saturn >> 2005 >> Relay FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 224 (Cruise Control System) >> Repair Instructions >> Cruise Control Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Steering Wheel Components
    GM1539232Courtesy of GENERAL MOTORS CORP.
  1. Install the cruise control switch (1).
  2. Install the steering wheel trim cover (3).
    3. NOTE: Refer to Fastener Notice .
  3. Install the cruise control switch screws (2).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  4. Install the steering wheel rear trim cover screws (4).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    5. Fig 2: Identifying Cruise Control Switch Components
    GM1539231Courtesy of GENERAL MOTORS CORP.
  5. Install the steering wheel electrical harness grounding screw (1).

    Tighten:  Tighten the screw to 6 N.m (53 lb in).

  6. Attach the electrical harness connector retainer clip (2) to the steering wheel trim cover.
  7. Install the steering wheel to the vehicle. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals